|
|
|
|
|
Hot-tube IgnitorA hot-tube ignitor was an early device that fit onto the cylinder head of an internal-combustion engine and ignites the compressed fuel/air mixture by means of a flame heating part of the tube red hot. A hot-tube ignitor consisted of a metal or porcelain tube, closed at one end and attached to the cylinder head at the other, and an adjustable burner that could be moved to position its flame at any point along the length of the tube. Compression in the cylinder compressed left over combustion products in the tube, forcing in fresh fuel/air mixture. When the compression was enough that the fuel reached the red hot area of the tube, ignition occurred. Timing was adjusted by moving the burner that generated the flame to change the position of the red hot spot on the tube. Hot-tube ignitors had many problems, most caused by the sudden pressure changes in the tube because of the operation of the engine and the high temperature of the tube. It was very hard to find materials that were both durable enough for these conditions and inexpensive. It was also very important never to make the mistake of setting the burner flame so that it heated the tube white hot, which rapidly damaged the tube and could cause it to burst explosively! This was an easy mistake to make and happened all too often. The tubes used were typically 6 to 12 inches long, which tended to make them impractical for use on anything but large engines (e.g., stationary motors in factories). Tubes rarely lasted longer than a year before needing replacement, especially when the engines were fueled with high sulfur gases like unpurified producer gas or high sulphur natural gas. External link *HOT TUBES and FLAMES
|
 |
|
| Copyright 2005-2009 OnPedia.com. All Rights Reserved |
|
|