|
|
|
|
|
XioWarning: this page is mostly conjectural. XIO is a packet-based, high-performance system bus employed by SGI Octane, Origin, Altix, Fuel and Tezro machines. The XIO forms a bus between high-performance system devices and the memory controller. XIO is usually used in a star topology, using a router called Xbow to connect up to 8 fully-symmetrical devices in a system (one of them is usually the memory controller / CPU bridge, called HEART in Octane or HUB in Origin). Other devices known to have XIO interfaces are: - BRIDGE: XIO to PCI-64 bridge (Octane, Origin)
- XBRIDGE: XIO to PCI-X bridge (Altix)
- HQ4: command processor of ImpactSR cards (Octane)
- KTOWN: frontend for InfiniteReality2 cards (Onyx, Origin variation)
- XC: Crosstown converter
The XIO employs two source-synchronous channels (one in each direction), each 8 or 16 bits wide. They are clocked at 400 MHz to achieve peak rates of 800 MB/s (ie. in megabytes). Each of the devices can utilize the full bandwidth, as the XBow router prevents collisions by being able to route between any two points. Transfer is organized into micropackets. These contain a total of 128 bits of data and 32 bits of control. The control information encapsulates an 8 bit sideband (used by higher layers for framing), sequence numbers (for go-back-n link-layer retransmissions) and check bits (CRC-16). It is probable that XIO uses STL (which SGI likes to call SGI transistor logic) low-voltage single-ended I/O standard. CrossTown is a version of XIO utilizing PECL for differential I/O standard (like CrayLink) for longer connections. Higher-level encapsulation differs from Craylink (like used to connect HUB chips in Origin-series machines). It is well suited for short memory transactions. XIO uses very fragile compression connectors, which should be handled with extreme care.
|
 |
|
| Copyright 2005-2009 OnPedia.com. All Rights Reserved |
|
|